The glow hides one level down on this five-dial skin diver

Vulcain’s Skindiver Mark II keeps the skin diver’s slim silhouette and rebuilds everything that shows on the wrist. The dial drops its markers into a recessed lower level, the bezel turns in ceramic, and the movement behind the dial now carries a COSC certificate.

Five dials, three straps and a single launch date carry the rest of the story here. Early access opens November 23, and the official launch follows on November 24.

Vulcain Skindiver Mark II
39 mm vertically brushed 316L steel case
Soprod M300 COSC automatic, 60-hour reserve
300 m water resistance, ceramic bezel
From CHF 1,950
On black rubber
More details at Vulcain
Early access Nov 23 · Launch Nov 24

A dial built in two levels

The two-level dial is the design decision everything else serves. Vulcain cuts the hour markers into the lower level and fills them with white Swiss Super-LumiNova, so the glow sits in deep recessed wells instead of sitting printed flat on the surface.

Macro of the Grey dial showing the recessed two-level markers and Vulcain Nautique signing
The Grey dial up close: recessed markers, applied indices, Vulcain Nautique signing at six

A domed sapphire crystal arcs over the arrangement, softening glancing angles.

Slim steel, rated for cold water

The case stays at 39 mm across and just 13.2 mm thick, cut from 316L stainless steel with a vertical brush. Those are skin diver dimensions, slimmer than the category usually ships.

Blue Skindiver Mark II on black rubber, worn on a wrist above a snowy shoreline
The Blue dial on black rubber, sitting small and flat the way a skin diver should

The rating breaks with the style entirely. Vulcain seals the case to 30 ATM, a full 300 m, and tops it with a black ceramic bezel that turns through 120 clicks in one direction.

A walker in an orange shell crosses a snow-covered Nordic coastline
The launch frames put the watch in Arctic Norway, where the water rating stops being a spec sheet line

A chronometer under a sapphire back

The Soprod M300 runs the watch, an automatic movement that beats at 28,800 vibrations an hour and holds a 60-hour reserve. COSC certification means an independent institute has tested and passed the movement’s timekeeping accuracy. It earns the word printed on the dial.

The Soprod M300 movement under the sapphire caseback, with the Vulcain-signed rotor
The caseback: Soprod M300 under sapphire, the rotor signed Vulcain

A sapphire caseback exposes the movement, and the rotor turns under it with Vulcain’s own decoration.

Five dials, three ways to wear it

The five dials are Black, Green, Blue, Salmon and Grey, each one priced by the strap it’s shown on. Black rubber starts the range, beads-of-rice steel sits in the middle, and the vintage steel bracelet tops it.

Green Skindiver Mark II worn on a wrist over a dark sleeve
The Green dial on the wrist under a dark sleeve

Vulcain prices the range in Swiss francs on its own page: CHF 1,950 on black rubber, CHF 2,070 on beads-of-rice and CHF 2,210 on vintage steel. The shown pairings put Blue and Salmon on rubber, Green and Grey on beads-of-rice, and Black on vintage steel. Rubber keeps the entry price lowest.

Vulcain Skindiver Mark II
39 mm vertically brushed 316L steel case
Soprod M300 COSC automatic, 60-hour reserve
300 m water resistance, ceramic bezel
From CHF 1,950
On black rubber
More details at Vulcain
Early access Nov 23 · Launch Nov 24

Buy the Skindiver Mark II if you want a chronometer movement in a 39 mm case at CHF 1,950 on black rubber. The two-level dial gives it a signature that rivals at this price simply don’t carry.

Skip it if you need a watch this week, since sales start November 24.

Leave a Comment

This site uses Akismet to reduce spam. Learn how your comment data is processed.